072 – HS Current Sensor 50A HV 4-14S
Code: Mauch-072
50A – Current measurement sensor board 4-14s max 60v
Includes DF13 cable, to use with Pixhawk 2 add the Clik Mate 2.0 cable available here
50A – Current measurement sensor board, based on Allegro Hall Sensor ACS-50U.
The voltage reading of the LiPo is optimised for up to 14S LiPo packs.
This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section.
The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry… etc.
Connected to the sensor are 2x10cm AWG12 wire (red) as a standard.
The board comes with
10cm connection cable (DF-13-6pDF-13-6p) to the FC for Pixhawk 1 or APM.
For Pixhawk 2 add the Clik Mate cable available here
Code: Mauch-072
50A – Current measurement sensor board 4-14s max 60v
Includes DF13 cable, to use with Pixhawk 2 add the Clik Mate 2.0 cable available here
50A – Current measurement sensor board, based on Allegro Hall Sensor ACS-50U.
The voltage reading of the LiPo is optimised for up to 14S LiPo packs.
This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section.
The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry… etc.
Connected to the sensor are 2x10cm AWG12 wire (red) as a standard.
The board comes with
10cm connection cable (DF-13-6pDF-13-6p) to the FC for Pixhawk 1 or APM.
For Pixhawk 2 add the Clik Mate cable available here
Code: Mauch-072
50A – Current measurement sensor board 4-14s max 60v
Includes DF13 cable, to use with Pixhawk 2 add the Clik Mate 2.0 cable available here
50A – Current measurement sensor board, based on Allegro Hall Sensor ACS-50U.
The voltage reading of the LiPo is optimised for up to 14S LiPo packs.
This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section.
The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry… etc.
Connected to the sensor are 2x10cm AWG12 wire (red) as a standard.
The board comes with
10cm connection cable (DF-13-6pDF-13-6p) to the FC for Pixhawk 1 or APM.
For Pixhawk 2 add the Clik Mate cable available here