073 - HS Current Sensor 100A LV 2-6S
Code: Mauch-073
100A - Current measurement sensor board 2-6s max 28v Includes DF13 cable, to use with Pixhawk 2 add the Clik Mate 2.0 cable available here
100A - Current measurement sensor board, based on Allegro Hall Sensor ACS-100U. The voltage reading of the LiPo is optimised for up to 6S LiPo packs. This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section. The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry... etc. Connected to the sensor are 2x10cm AWG12 wire (red) as a standard. The board comes with
10cm connection cable (DF-13-6pDF-13-6p) to the FC for Pixhawk 1 or APM.
For Pixhawk 2 add the Clik Mate cable available here
Code: Mauch-073
100A - Current measurement sensor board 2-6s max 28v Includes DF13 cable, to use with Pixhawk 2 add the Clik Mate 2.0 cable available here
100A - Current measurement sensor board, based on Allegro Hall Sensor ACS-100U. The voltage reading of the LiPo is optimised for up to 6S LiPo packs. This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section. The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry... etc. Connected to the sensor are 2x10cm AWG12 wire (red) as a standard. The board comes with
10cm connection cable (DF-13-6pDF-13-6p) to the FC for Pixhawk 1 or APM.
For Pixhawk 2 add the Clik Mate cable available here
Code: Mauch-073
100A - Current measurement sensor board 2-6s max 28v Includes DF13 cable, to use with Pixhawk 2 add the Clik Mate 2.0 cable available here
100A - Current measurement sensor board, based on Allegro Hall Sensor ACS-100U. The voltage reading of the LiPo is optimised for up to 6S LiPo packs. This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section. The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry... etc. Connected to the sensor are 2x10cm AWG12 wire (red) as a standard. The board comes with
10cm connection cable (DF-13-6pDF-13-6p) to the FC for Pixhawk 1 or APM.
For Pixhawk 2 add the Clik Mate cable available here